Administrator Guide
Defaults threshold = 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information If you configure the neighbor maximum-prefix command and the neighbor receives more prefixes than
allowed by the neighbor maximum-prefix command configuration, the neighbor goes down and the show
ip bgp summary command displays (prfxd) in the State/PfxRcd column for that neighbor. The neighbor
remains down until you enter the clear ip bgp command for the neighbor or the peer group to which the
neighbor belongs or you enter the neighbor shutdown and neighbor no shutdown commands.
Related
Commands
show ip bgp summary – displays the current BGP configuration.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
C9000 Series
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self [all]
To return to the default setting, use the no neighbor {ipv6-address | peer-group-name} next-
hop-self [all] command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
all Specifies that the route reflector is the next hop for both iBGP and eBGP-learned routes.
Defaults Disabled.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.10(0.0) Introduced the all keyword on the S4810, S4820, S4048–ON, S3048–ON, S3100 series,
S6010–ON, S4040T-ON, S5000, S6000, S6000–ON, S6100–ON, Z9100–ON, and
Z9500.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information
If you configure the set ipv6 next-hop command in ROUTE-MAP mode, its configuration takes precedence
over the neighbor next-hop-self command.
If you do not use the all keyword, the next hop of only eBGP-learned routes is updated by the route reflector. If
you use the all keyword, the next hop of both eBGP- and iBGP-learned routes are updated by the route
reflector.
452 Border Gateway Protocol