Administrator Guide

vrfv4acl number Enter the keyword vrfv4acl and then the number of FP blocks for VRF IPv4 ACL. The
range is from 0 to 2.
l2acl number
ipv4acl number
ipv6acl number ,
ipv4qos number
l2qos number l2pt
number ipmacacl
number ecfmacl
number
{nlbclusteracl]
[vman-qos |
vman-dual-qos
number ] ipv4pbr
number openflow
{4|8} | fcoe
number
[iscsioptacl
number ] [vrfv4acl
number ]
Allocate space to each CAM region.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller (256 total entries minus the
14 entries reserved for internal functionality)
• 8: Creates 498 entries for use by the OpenFlow controller (512 total entries minus the
14 entries reserved for internal functionality)
The fcoe range is 0–6 groups. Each group has 128 entries; the value given must be an
even number. This information is stored in the NVRAM and is effective after rebooting
the switch.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Clarified block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system
for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks; these blocks cannot be
reallocated. Only 12 number of blocks can be configured by the user .
There can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in factors of 2. For
example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of 6+4+2+1 Blocks is
supported.
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
480 Content Addressable Memory (CAM)