Administrator Guide

Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information When you enable this command, if a Policy Map containing classification rules (ACL and/or dscp/ ip-precedence
rules) is applied to more than one physical interface on the same port pipe, only a single copy of the policy is
written (only one FP entry is used). Use this command in Configuration Terminal Batch mode to enable the
settings in a dual-homing setup.
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of
interfaces. For more information, refer to the “IP Access Control Lists”, “Prefix Lists”, and
“Route-map” sections in the Dell Networking OS Configuration Guide .
cam-threshold
Configure CAM threshold value for sending the syslog message on CAM usage. Configure silence period for stop receiving syslog message
on CAM usage.
Syntax
cam-threshold threshold {default | threshold-percent} silence-period {default |
silence-period-value}
Defaults
Enabled
Parameters
threshold default
Enter the keyword default for CAM usage threshold for notification of the CAM usage
through syslog message. The default threshold value is 90 percent.
threshold
threshold-percent
Enter the threshold percent for notification of the CAM usage through syslog message.
The range is from 1 to 100 percent.
silence-period
default
Enter the keyword default to set the silence period for receiving syslog message
regarding CAM usage for CAM region, slot/portpipe. The default silence period is 0
seconds.
silence-period
silence-period-
value
Enter the silence period for stop receiving syslog message for the respective CAM region,
slot/portpipe. The range is from 0 to 65535 seconds.
Command Modes CONFIGURATION
Supported Modes
Content Addressable Memory (CAM) 483