Administrator Guide

Command History
Version Description
9.13.0.0 Introduced on the MXL, FN IOM, S5000, S4048-ON, S6000, S6000-ON, S3048-ON,
S3100 Series, C9010, S4048T-ON, Z9500, Z9100-ON, S6100-ON, S6010-ON.
Usage Information
The no cam-threshold command will set the CAM threshold to 90 percent and silence period to 0.
The CAM threshold and silence period configuration is applicable only for Ingress L2, IPv4, IPv6 and Egress L2,
IPv4, and IPv6 ACL CAM groups. For other ACL CAM regions, the CAM threshold and silence period is not
configurable and the values are fixed to 90 percent and 0 respectively.
Example
DellEMC(conf)#cam-threshold threshold 2 silence-period 2
DellEMC(conf)#do show running-config | g cam-threshold
cam-threshold threshold 2 silence-period 2
show cam-acl
Display the details of the CAM profiles on the chassis and all stack units.
C9000 Series
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series.
Usage Information The display reflects the settings implemented with the cam-acl command.
Example
show cam-usage
Display the amount of memory space used and available in each CAM partition (including Layer 2 ACL, Layer 3 ACL, and IPv4Flow).
Syntax
show cam-usage [acl | router | switch]
Parameters
acl
(OPTIONAL) Enter the keyword acl to display Layer 2 and Layer 3 ACL CAM usage.
router
(OPTIONAL) Enter the keyword router to display Layer 3 CAM usage.
switch
(OPTIONAL) Enter the keyword switch to display Layer 2 CAM usage.
484 Content Addressable Memory (CAM)