Administrator Guide

PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mbps) Burst(KB)
-------------------------------------------------------------------------
0 0,1,2,3,4,5,6,7 100 - - - - ETS
1 - - - - - -
2 - - - - - -
3 - - - - - -
4 - - - - - -
5 - - - - - -
6 - - - - - -
7 - - - - - -
Oper status is init
ETS DCBX Oper status is Down
Reason: Port Shutdown
State Machine Type is Asymmetric
Conf TLV Tx Status is enabled
Reco TLV Tx Status is enabled
DCBX Commands
The following DCBX commands are supported on the Dell Networking OS.
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
C9000 Series
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco | pfc]
[ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
{ets-conf | ets-
reco | pfc}
Enter the PFC and ETS TLVs advertised, where:
• ets-conf: enables the advertisement of ETS configuration TLVs.
• ets-reco: enables the advertisement of ETS recommend TLVs.
• pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB) 525