Administrator Guide

mgmt | resource |
sem | tlv}
• config-exchng: enables traces for DCBX configuration exchanges.
• fail: enables traces for DCBX failures.
• mgmt: enables traces for DCBX management frames.
• resource: enables traces for DCBX system resource frames.
• sem: enables traces for the DCBX state machine.
• tlv: enables traces for DCBX TLVs.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 .
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
C9000 Series
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Defaults 0x8
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command is available at the global level only.
528 Data Center Bridging (DCB)