Administrator Guide

tsensorAccess: ALL RUN YES NO NO NO NO
usbAccess: ALL RUN YES NO NO NO NO
usbPowerEnable: ALL RUN YES NO NO NO NO
usbRW: ALL RUN NO YES NO NO NO
usbStatus: ALL RUN YES NO NO NO NO
watchdogTimer: ALL RUN NO NO NO NO YES
Hardware Commands
The hardware commands supported on the switch allow you to display information from a hardware sub-component or ASIC.
clear control-traffic
Clear control-traffic statistics from the CPU.
C9000 Series
Syntax
clear control—traffic {all | cp—switch | linecard slot-id portset port-pipe}
counters
Parameters
cp-switch Enter the keyword cp-switch to clear the counters for control traffic on the control
plane.
linecard slot-id
portset port-pipe
Enter the slot ID and port pipe to clear the counters for control traffic on a specified
switch line card and port set. The range of slot IDs is from 0 to 2. The range of port-pipe
numbers is: 0 to 2 on line card 0 and 0 to 3 on line cards 1 and 2.
all Enter the keyword all to clear control-traffic statistics on the control plane and all line
cards.
Defaults None.
Command Modes EXEC Privilege
Example
Dell# clear control-traffic cp-switch counters
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the ES-Series.
clear hardware
Clear statistics from a specified hardware component.
C9000 Series
Syntax
clear hardware {cp {cpu {data-plane | i2c statistics | sata-interface}} | cp-
switch {counters} | linecard slot-id {counters | cpu {data-plane | i2c | sata-
interface} statistics} | hg-stats| unit unit-num {counters} | party-bus
{counters} | pe pe-id stack-unit unit-number {counters | cpu | stack—port |
564 Debugging and Diagnostics