Administrator Guide

Version Description
7.8.1.0 Introduced on the S-Series.
Related
Commands
show hardware — displays the data plane or management plane input and output statistics for a specified
hardware component.
remote-exec
Debug and troubleshoot switch hardware using remote commands.
NOTE: Use the remote-exec command only with the guidance of an engineer from Dell Networking Technical Support.
C9000 Series
Syntax
remote-exec {cp | rp | linecard slot-id} hw-command
Parameters
cp Enter the keyword cp to troubleshoot Control Processor CPU operation.
rp Enter the keyword rp to troubleshoot Route Processor CPU operation.
linecard slot-id Enter the linecard slot-id to troubleshoot line-card CPU operation. The range of
line-card slot IDs is from 0 to 11. Each line-card CPU processes packets on the
corresponding line card on your switch.
hw-command Enter the debug command that Dell Networking Technical Support gives you.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Modified the drops keyword range, unit keyword range and added the buffer and
cpu management statistics options.
8.3.19.0 Introduced on the S4820T.
8.3.11.5 Added i2c statistics and sata-interfaces statistics.
8.3.11.4 Added user port information.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
Usage Information Use the remote-exec command to remotely execute a command on the Route Processor and line-card (LP)
processor from the Control Processor.
Related
Commands
show hardware — displays information on hardware components.
Debugging and Diagnostics 567