Administrator Guide

Offset: 71 Width: 2
DATA=0x00000001
MASK=0x00000001
action={act=CopyToCpuCancel, param0=0(0), param1=0(0), param2=0(0),
param3=0(0)}
action={act=EtagNew, param0=327687(0x50007), param1=0(0),
param2=0(0), param3=0(0)}
policer=
statistics={stat id 167 slice = 6 idx=0 entries=1}{Packets}
show hardware ipv6
Display information about IPv6 ACLs used on a line card and port pipe.
C9000 Series
Syntax
show hardware ipv6 {eg-acl | in-acl} linecard slot-id port-set port-pipe
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to display ingress or egress
ACL data.
linecard slot-id Enter the linecard slot-id parameters to specify a line card on the switch. The
range of slot IDs is from 0 to 2.
port-set port-pipe Enter the keywords port-set port-pipe parameters to specify a port pipe (set of
ports) on a line card. The range of port-pipe numbers is: 0 to 2 on line card 0 and 0 to 3
on line cards 1 and 2.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Example
Dell#show hardware ipv6 eg-acl linecard 0 port-set 0
EID 0x000013ce: gid=0xd,
slice=0, slice_idx=0, part =0 prio=0x13ce, flags=0x10202,
Installed, Enabled
tcam: color_indep=0,
StageEgress
slice=1, slice_idx=0, part =1 prio=0x13ce, flags=0x10204,
Installed, Enabled
tcam: color_indep=0,
Offset: 1 Width: 8
DATA=0x0000003a
MASK=0x000000ff
IpType
Offset: 208 Width: 5
DATA=0x00000004
MASK=0x0000000c
Debugging and Diagnostics 585