Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
disable
Disable the DHCP server.
C9000 Series
Syntax
disable
DHCP Server is disabled by default. To enable the system to be a DHCP server, use the no disable command.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
dns-server
Assign a DNS server to clients based on address pool.
C9000 Series
Syntax
dns-server address [address2...address8]
Parameters
address Enter a list of DNS servers that may service clients on the subnet. You may list up to eight
servers, in order of preference.
Defaults none
Command Modes DHCP <POOL>
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
596 Dynamic Host Configuration Protocol (DHCP)