Administrator Guide

1000Base-T Control
MasterSlave_Mode : Auto
1000MegFullDplx : True
1000MegHalfDplx : False
1000Base-T Status
Master/Slave Fault : No
Master/Slave : Slave
Local RX OK : False
Remote RX OK : False
Link Partner 1G FD : False
Link Partner 1G HD : False
Idle Err Cnt : 0
PHY Extended Control
MDI Crossover_mode : Enabled
Example
Related
Commands
show interfaces — displays information on a specific physical interface or virtual interface.
show interfaces status
To display status information on a specific interface only, display a summary of interface information or specify a line card slot and
interface.
C9000 Series
Syntax
show interfaces [interface | linecard slot-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port (ports or port-range) information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port (ports or port-range) information.
•
For a Loopback interface, enter the keyword loopback then the slot/port
information. The range is from 0 to 16383.
• For a Port-Channel interface, enter the keyword port-channel then the number.
The range is from 0 to 128.
• For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the
pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28 or
49 to 52 depending on the PE.
NOTE: The peGigE or peTenGigE interface option is only visible when the
feature extended bridge is enabled.
linecard slot-
number
(OPTIONAL) Enter the keyword linecard then the slot number. The slot ID is from 0 to
11.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Interfaces 733