Administrator Guide
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
• For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id/ stack-unit unit number /port-ID information.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28 or
49 to 52 depending on the PE.
linecard
slot-id
(OPTIONAL) Enter the interface port-type slot/port parameters to display
the ARP entries learned on a Z9500 port. The range of slot IDs is from 0 to 2.
ip
ip-address mask
(OPTIONAL) Enter the keyword ip with an IP address in the dotted decimal format to
display the ARP entries learned with this IP address. Enter the optional IP address mask in
the slash prefix format (/ x).
macaddress
mac-
address mask
(OPTIONAL) Enter the keyword macaddress with a MAC address in nn:nn:nn:nn:nn:nn
format to display the ARP entries learned with this MAC address. Enter the optional MAC
address mask in nn:nn:nn:nn:nn format also.
static (OPTIONAL) Enter the keyword static to display manually-entered ARP entries.
dynamic (OPTIONAL) Enter the keyword dynamic to display dynamically-learned ARP entries.
summary (OPTIONAL) Enter the keyword summary to view a summary of ARP entries.
Default Display only the ARP entries learned on the Control Processor.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.8.1.0 Augmented to display local ARP entries learned from private VLANs (PVLANs).
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information
Use the show arp command to display the ARP entries learned on the Control Processor and Route Processor.
IPv4 Routing 893