Administrator Guide
nlbclusteracl
number
Enter nlbclusteracl and the FP block number for NLB Cluster ACL. The FP block
number range is 0 to 6.
ipv4pbr
number
Enter ipv4pbr and the FP block number for IPv4 PBR ACL. The FP block number range
is 0 to 6.
iscsioptacl
number
Enter iscsioptacl and the FP block number for ISCSI optimization ACL. The FP block
number range is 0 to 6.
openflow
number
Enter openflow and the FP block number for OpenFlow ACL. The FP block number
range is 0 to 6.
vrfv4acl
number
Enter vrfv4acl and the FP block number for VRF ACL. The FP block number range is 0
to 6.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Added support for the fcoe parameter on the S4810 and S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or copy
run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires four blocks and these blocks cannot be
reallocated. The total number of blocks must be equal to 12. The ipv4acl profile range is from 0 to 8.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 12.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any configuration changes that have
changed the NVRAM content, use the
reload conditional nvram-cfg-change command.
You can use the cam-acl default command in Configuration Terminal Batch mode to reset ACL CAM entries
to default settings in a dual-homing setup.
916 IPv6 Access Control Lists (IPv6 ACLs)