Administrator Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.1.0 Introduced on the E-Series TeraScale.
Usage Information You can separately configure both IPv4 and IPv6 domain name servers.
ipv6 nd dad attempts
Configure the number of neighbor solicitation messages that are sent to perform duplicate address detection (DAD) on the interface.
C9000 Series
Syntax
ipv6 nd dad attempts {number of attempts}
To restore the default value, use the no ipv6 nd dad attempts command.
Parameters
number of
attempts
Enter the number of attempts to be made to detect a duplicate address. The range is
from 0 to 15. Setting the value to 0 disables DAD on the interface.
Default 3 attempts
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
ipv6 nd disable-reachable-timer
Keep the learnt neighbor discovery entries stateless so that the entries do not time out.
Syntax
ipv6 nd disable-reachable-timer
To restore to default, use the no ipv6 nd disable-reachable-timer command.
942 IPv6 Basics