Administrator Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added support for sticky MAC addresses.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
mac-address-table aging-time
Specify an aging time for MAC addresses to remove from the MAC address table.
C9000 Series
Syntax
mac-address-table aging-time seconds
Parameters
seconds Enter either zero (0) or a number as the number of seconds before MAC addresses are
relearned. To disable aging of the MAC address table, enter 0. The range is from 10 to
1000000. The default is 1800 seconds.
Defaults 1800 seconds
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 On the E-Series, available in INTERFACE VLAN context, reduced the minimum aging time
in the INTERFACE VLAN context from 10 seconds to 1 second.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Layer 2 969