Users Guide

• Management Interfaces
• Port Extender Interfaces
• VLAN Interfaces
• Loopback Interfaces
• Null Interfaces
• Port Channel Interfaces
• Bulk Conguration
• Dening Interface Range Macros
• Monitoring and Maintaining Interfaces
• Displaying Trac Statistics on HiGig Ports
• Link Bundle Monitoring
• Monitoring HiGig Link Bundles
• Non Dell-Qualied Transceivers
• Splitting QSFP Ports to SFP+ Ports
• Conguring wavelength for 10–Gigabit SFP+ optics
• Link Dampening
• Using Ethernet Pause Frames for Flow Control
• Congure the MTU Size on an Interface
• Auto-Negotiation on Ethernet Interfaces
• Provisioning Combo Ports
• View Advanced Interface Information
• Conguring the Trac Sampling Size Globally
• Dynamic Counters
Port Numbering
On the C9010, linecard slots are numbered 0 to 9. The RPM slots are numbered 10 and 11.
NOTE
: If the C9010 operates with only one RPM, you can install the RPM in either slot 10 (the top RPM slot labeled R0) or slot
11 (the bottom RPM slot labeled R1). If you install two RPMs, by default, the RPM in slot 10 is the primary management unit and
the RPM in slot 11 is the standby. In software command output, the RPM in slot 10 (R0) is displayed as rpm0; the RPM in slot 11
(R1) is displayed as rpm1
434 Interfaces