Administrator Guide

ipv6 address 1212::12/64
ipv6 nd dns-server 1000::1 1
ipv6 nd dns-server 3000::1 1
ipv6 nd dns-server 2000::1 0
no shutdown
Secure Shell (SSH) Over an IPv6 Transport
Both inbound and outbound secure shell (SSH) sessions using IPv6 addressing are supported.
Inbound SSH supports accessing the system through the management interface as well as through a physical Layer 3 interface.
For SSH configuration details, refer to the Security chapter in the Dell Networking OS Command Line Interface Reference Guide.
Configuration Tasks for IPv6
The following are configuration tasks for the IPv6 protocol.
• Adjusting Your CAM-Profile
• Assigning an IPv6 Address to an Interface
• Assigning a Static IPv6 Route
• Configuring Telnet with IPv6
• SNMP over IPv6
• Showing IPv6 Information
• Clearing IPv6 Routes
Adjusting Your CAM Profile
Although adjusting your CAM profile is not a mandatory step, if you plan to implement IPv6 ACLs, Dell Networking recommends that you
adjust your CAM settings.
The CAM space is allotted in FP blocks. The total space allocated must equal 13 FP blocks. There are 16 FP blocks, but the System Flow
requires three blocks that cannot be reallocated.
You must enter the ipv6acl allocation as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use either even or odd-numbered
ranges.
The default option sets the CAM Profile as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
To have the changes take effect, save the new CAM settings to the startup-config (write-mem or copy run start) then reload the
system for the new settings.
• Allocate space for IPV6 ACLs. Enter the CAM profile name then the allocated amount.
CONFIGURATION mode
cam-acl { ipv6acl }
When not selecting the default option, enter all of the profiles listed and a range for each.
The total space allocated must equal 13.
The ipv6acl range must be a factor of 2.
• Show the current CAM settings.
EXEC mode or EXEC Privilege mode
show cam-acl
• Provides information on FP groups allocated for the egress acl.
CONFIGURATION mode
show cam-acl-egress
Allocate at least one group for L2ACL and IPv4 ACL.
456
IPv6 Routing