Administrator Guide

NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is
separated by a colon (:). Omitting zeros is accepted as described in Addressing.
SNMP over IPv6
You can configure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive SNMP notifications from a
device running a Dell Networking OS that supports IPv6.
The SNMP-server commands for IPv6 have been extended to support IPv6. For more information regarding SNMP commands, refer to
the SNMP and SYSLOG chapters in the Dell Networking OS Command Line Reference Guide.
•
snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Displaying IPv6 Information
To view a specified IPv6 configuration, use the show ipv6command.
• List the IPv6 show options.
EXEC mode or EXEC Privileged mode
show ipv6 ?
Dell#show ipv6 ?
accounting IPv6 accounting information
cam IPv6 CAM Entries
fib IPv6 FIB Entries
interface IPv6 interface information
mbgproutes MBGP routing table
mld MLD information
mroute IPv6 multicast-routing table
neighbors IPv6 neighbor information
ospf OSPF information
pim PIM V6 information
prefix-list List IPv6 prefix lists
route IPv6 routing information
rpf RPF table
Dell#
Displaying an IPv6 Configuration
To view the IPv6 configuration for a specific interface, use the following command.
• Display the currently running configuration for a specified interface.
EXEC mode
show ipv6 interface type {slot/port}
Enter the keyword interface then the type of interface and slot/port information:
• For all brief summary of IPv6 status and configuration, enter the keyword brief.
• For all IPv6 configured interfaces, enter the keyword configured.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
• For a port extender (PE) Gigibait Ethernet interface, enter the keywords peGigE then thepeGigE pe-id/pe-stack-unit-id/port-
number information.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE then the pe-id/stack-unit /port-id information.
• For a loopback interface, enter the keyword loopback then the loopback number.
• For a port-channel interface, enter the keywords port-channel then the port-channel number.
458
IPv6 Routing