Administrator Guide

N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 10.11.10.0/24 via 10.11.20.2, Te 3/21 120/1 00:01:14
C 10.11.20.0/24 Direct, Te 3/21 0/0 00:01:53
C 10.11.30.0/24 Direct, Te 3/11 0/0 00:06:00
R 10.200.10.0/24 via 10.11.20.2, Te 3/21 120/1 00:01:14
R 10.300.10.0/24 via 10.11.20.2, Te 3/21 120/1 00:01:14
C 192.168.1.0/24 Direct, Te 3/43 0/0 00:06:53
C 192.168.2.0/24 Direct, Te 3/44 0/0 00:06:26
Core3#
To view the RIP configuration activity on Core 3, use the show ip protocols command.
Core3#show ip protocols
Routing Protocol is "RIP"
Sending updates every 30 seconds, next due in 6
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
TenGigabitEthernet 3/21 2 2
TenGigabitEthernet 3/11 2 2
TenGigabitEthernet 3/44 2 2
TenGigabitEthernet 3/43 2 2
Routing for Networks:
10.11.20.0
10.11.30.0
192.168.2.0
192.168.1.0
Routing Information Sources:
Gateway Distance Last Update
10.11.20.2 120 00:00:22
Distance: (default is 120)
Core3#
RIP Configuration Summary
The following example shows viewing the RIP configuration on Core 2.
!
interface TengigabitEthernet 2/11
ip address 10.11.10.1/24
no shutdown
!
interface TengigabitEthernet 2/31
ip address 10.11.20.2/24
no shutdown
!
interface TengigabitEthernet 2/41
ip address 10.200.10.1/24
no shutdown
!
interface TengigabitEthernet 2/42
ip address 10.250.10.1/24
no shutdown
router rip
version 2
774
Routing Information Protocol (RIP)