Administrator Guide

port-channel-protocol lacp
Enable LACP on any LAN port.
C9000 Series
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp command.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.2.1.1 Introduced on the E-Series.
Related
Commands
• show lacp — displays the LACP information.
• show interfaces port-channel — displays information on configured Port Channel groups.
show lacp
Display the LACP matrix.
C9000 Series
Syntax
show lacp port-channel-number [sys-id | counters]
Parameters
port-channel-
number
Enter a port-channel number. The range is from 1 to 128.
sys-id (OPTIONAL) Enter the keywords sys-id and the value that identifies a system.
counters (OPTIONAL) Enter the keyword counters to display the LACP counters.
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
Link Aggregation Control Protocol (LACP) 1003