Administrator Guide

Parameters
management-
address
Enter the keywords management-address to advertise the management IP address
TLVs to the specified interface.
system-
capabilities
Enter the keywords system-capabilities to advertise the system capabilities TLVs
to the specified interface.
system-
description
Enter the keywords system-description to advertise the system description TLVs
to the specified interface.
system-name Enter the keywords system-name to advertise the system name TLVs to the specified
interface.
Defaults none
Command Modes INTERFACE (conf-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the Z9000 and S4810.
8.3.19.0 Introduced on the S4820T.
clear lldp counters
Clear LLDP transmitting and receiving counters for all physical interfaces or a specific physical interface.
C9000 Series
Syntax
clear lldp counters interface
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a Management Ethernet interface, enter the keyword managementethernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet then
the slot/port information.
• For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the
pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28 or
49 to 52 depending on the PE.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Link Layer Discovery Protocol (LLDP) 1009