Administrator Guide

To turn off debugging, use the no debug ipv6 mld {group-address | interface} command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF.
group-address (OPTIONAL) Enter the multicast group address in the x:x:x:x::x format. The :: notation
specifies successive hexadecimal fields of zero.
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(3.0) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6000–ON, S6010–ON,
S6100–ON, Z9100–ON, S3100, and C9010.
ipv6 mld explicit-tracking
Enable MLD explicit tracking receivers.
Syntax
ipv6 mld explicit-tracking
To disable explicit tracking, use the no ipv6 mld explicit-tracking command.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(3.0) Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6000–ON, S6010–ON,
S6100–ON, Z9100–ON, S3100, and C9010.
ipv6 mld last-member-query-interval
Change the MAX Response Time inserted into the Group-Specific Queries sent in response to a Leave Group messages. This interval is
also the interval between Group-Specific Query messages.
Syntax
ipv6 mld last-member-query-interval {milliseconds}
To return to the default, use the no ipv6 mld last-member-query-interval {milliseconds}
command.
Parameters
milliseconds Enter the last member query interval in milliseconds. The range is from 100 to 65535.
Defaults 1000 milliseconds.
Command Modes INTERFACE
Multicast Listener Discovery Protocol 1043