Administrator Guide

managed-config-flag
Set the managed address configuration flag.
Syntax
managed-config-flag {on | off}
To clear the flag, use the no managed-config-flag {on | off} command.
Parameters
on Enter the keyword on to set the managed-config-flag value as ON.
off Enter the keyword off to set the managed-config flag value as OFF.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the C9010.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
Related
Commands
• ipv6 nd ra-guard enable — configure the RA guard related commands.
• ipv6 nd raguard policy policy-name — define the router advertisement (RA) guard policy name and enter the
RA guard policy configuration mode.
match ra
Enable verifying either of the configured source IPv6 address or prefix address or the source MAC address in the inspected messages. If
this command is not configured, the verification process is bypassed.
Syntax
match ra {ipv6-access-list name | ipv6-prefix-list name | mac-access-list name}
To reset the access list, use the no match ra{ipv6-access-list | ipv6-prefix-list | mac-
access-list}command.
Parameters
ipv6–access-list
name
Enter the keywords ipv6–access-list then the access-list name. The access-list
name allows a maximum of 140 characters.
ipv6–prefix-list
name
Enter the keywords ipv6–prefix-list then the prefix-list name. The prefix-list name
allows a maximum of 140 characters.
ipv6–mac-access-
list name
Enter the keywords ipv6–mac-access-list then the mac-access-list name. The
mac-access-list name allows a maximum of 140 characters.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the C9010.
9.9(0.0) Introduced on the Z9500.
Neighbor Discovery Protocol (NDP) 1083