Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Example
Dell#debug track all
04:35:04: %RPM0-P:RP2 %OTM-5-STATE: track 6 - Interface TenGigabitEthernet
1/2/1
line-protocol DOWN
04:35:04: %RPM0-P:RP2 %OTM-5-NOTIF: VRRP notification: resource ID 6 DOWN
delay
Configure the time delay used before communicating a change in the status of a tracked object to clients.
C9000 Series
Syntax
delay {[up seconds] [down seconds]}
To return to the default setting, use the no delay command.
Parameters
seconds Enter the number of seconds the object tracker waits before sending a notification about
the change in the UP and/or DOWN state of a tracked object to clients. The range is 0 to
180. The default is 0 seconds.
Defaults 0 seconds
Command Modes OBJECT TRACKING (conf_track_object-id)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information
To set the time delay before a change in the state of a tracked object is communicated to clients configure an UP
and/or DOWN timer for each tracked object. The configured time delay starts when the state changes from UP
to DOWN or vice-versa.
If the state of an object changes back to its former UP/DOWN state before the timer expires, the timer is
cancelled and the client is not notified. For example, if the DOWN timer is running when an interface goes down
and comes back up, the DOWN timer is cancelled and the client is not notified of the event.
If the timer expires and an object’s state has changed, a notification is sent to the client. If you do not configure a
delay timer, a notification is sent immediately after a change in the state of a tracked object is detected. The time
delay in communicating a state change is specified in seconds.
Related
Commands
• track interface ip routing – configures object tracking on the routing status of an IPv4 Layer 3 interface.
• track interface line-protocol – configures object tracking on the line-protocol state of a Layer 2 interface.
• track ip route metric threshold – configures object tracking on the threshold of an IPv4 route metric.
Object Tracking 1091