Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
log-adjacency-changes
To send a Syslog message about changes in the OSPF adjacency state, set the system.
C9000 Series
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes command.
Defaults Disabled.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
maximum-paths
Enable the software to forward packets over multiple paths.
C9000 Series
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths command.
1132 Open Shortest Path First (OSPFv2 and OSPFv3)