Administrator Guide

power-cycle
Power-cycle the port extender (PE) stack-unit from the PE console
C9000 Series
Syntax
power-cycle stack-unit {unit-number | all }
Parameters
unit-number Enter a stack-unit number. Range is from 0 to 7.
all Enter all to power-cycle all the stack-units.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 and C1048P.
Usage Information
CAUTION: Do not attempt to reset or power cycle when the system is going through the process
of upgrading.
Example
Dell#power-cycle ?
stack-unit Stack-unit
Dell#power-cycle stack-unit ?
<0-7> Unit number
all Entire stack
Dell#power-cycle stack-unit 0
Dell#power-cycle stack-unit all ?
show control-bridge status
Display the status of the control bridge from the port extender (PE) console.
C9000 Series
Syntax
show control-bridge status
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C1048P.
Example
Dell#show control-bridge status
Reason: CNU - CSP Not Up, IPE - IPC Program Error
PPE - PEM Program Error, CPE - CHM Program Error
UE - UnKnown Error
CB System MAC : 34:17:eb:00:20:00
PE Console Commands 1207