Administrator Guide
PIM-Source Specific Mode (PIM-SSM)
The protocol-independent multicast source-specific mode (PIM-SSM) commands in this section are supported in the Dell Networking
operating system.
Topics:
• IPv4 PIM Commands
• IPv4 PIM-Source Specific Mode Commands
IPv4 PIM Commands
The following commands apply to IPv4 PIM-SM, IPv4 PIM-SSM, and PIM-DM.
• clear ip pim tib
• debug ip pim
• ip pim dr-priority
• ip pim neighbor-filter
• ip pim query-interval
• show ip pim interface
• show ip pim neighbor
• show ip pim tib
clear ip pim tib
Clear PIM tree information from the PIM database.
C9000 Series
Syntax
clear ip pim tib [group]
Parameters
group (OPTIONAL) Enter the multicast group address in dotted decimal format (A.B.C.D).
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage Information If you use this command on a local VLT node, all multicast routes from the local PIM TIB, the entire multicast route
table, and all the entries in the data plane are deleted. The local VLT node sends a request to the peer VLT node
43
PIM-Source Specific Mode (PIM-SSM) 1239