Administrator Guide

Field Description
Incoming interface Displays the reverse path forwarding (RPF) interface towards the RP/ source.
RPF neighbor Displays the next hop from this interface towards the RP/source.
Outgoing
interface list:
Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group
• statically configured member of the Group
• received a (*,G) Join message
Example
Dell#do show ip pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned,
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT,
M - MSDP created entry, A - Candidate for MSDP Advertisement
K - Ack-Pending State
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 225.1.1.1), uptime 00:40:16, expires 00:00:00, RP 20.40.4.4, flags: SCJ
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
(20.10.4.9, 225.1.1.1), uptime 00:06:21, expires 00:02:06, flags: CT
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
(*, 225.1.1.2), uptime 00:40:15, expires 00:00:00, RP 20.40.4.4, flags: SCJ
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
(20.10.4.9, 225.1.1.2), uptime 00:06:21, expires 00:02:06, flags: CT
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
IPv4 PIM-Source Specific Mode Commands
The following IPv4 PIM-source specific mode (PIM-SSM) commands are supported:
• ip pim ssm-range
• show ip pim ssm-range
ip pim ssm-range
Specify the SSM group range using an access list.
C9000 Series
Syntax
ip pim ssm-range {access_list_name}
Parameters
access_list_name Enter the name of the access list.
Defaults Default SSM range is 232/8 and ff3x/32
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
1246 PIM-Source Specific Mode (PIM-SSM)