Administrator Guide

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the C9010, S3048–ON, S3100 Series, S4048–ON, S4048T–ON, S6000–
ON, S6010–ON, S6100–ON, Z9100–ON.
Usage Information Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ipv6 pim sparse-mode
Enable IPv6 PIM sparse mode and MLD on the interface.
Syntax
ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode and MLD on the interface, use the no ipv6 pim sparse-mode command.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100,
S6010-ON, S3048-ON, and C9010.
Usage Information Enable the interface (use the no shutdown command) and not have the switchport command configured.
Also enable Multicast globally. PIM is supported on the port-channel interface.
ipv6 pim sparse-mode sg-expiry-timer
Enable expiry timers globally for all sources.
Syntax
ipv6 pim [vrf vrf-name] sparse-mode sg-expiry-timer seconds
To disable configured timers and return to default mode, use the no ipv6 pim sparse-mode sg-expiry-
timer command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable expiry
timer for all sources on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
seconds Enter the number of seconds the S, G entries are retained. The range is from 211 to
65535.
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100,
S6010-ON, S3048-ON, and C9010.
Usage Information This command configures an expiration timer for all S.G entries, unless they are assigned to an Extended ACL.
PIM-Sparse Mode (PIM-SM) 1275