Administrator Guide

feature extended-bridge
Enable 802.1BR (bridge port extender) support on the switch.
C9000 Series
Syntax
[no] feature extended-bridge
To disable 802.1BR support on the switch, use the no feature extended-bridge command.
Default None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
Usage Information
This command enables support for the 802.1 bridge PE (BR) on the switch. Enabling the PE feature allows you to
provision the PE. The no feature extended-bridge command disables bridge PE support and deprovisions
a PE. When you use this command in the Configuration Terminal Batch mode, you can enable the support for the
bridge PE connected in a Dual-Homing setup.
You can use the show feature command to check whether the extended-bridge feature has been enabled as
shown in the following example.
Example
Dell>show feature
Feature State
------- -----
VRF disabled
Extended-Bridge enabled
Related
Commands
pe provision — Logically provision or add a PE.
location-led
Toggle the location LED of a specified interface, linecard or port extender (PE) on or off.
C9000 Series
Syntax
location—led {interface interface | linecard slot-id | pe pe-id stack-unit
unit-number | rpm slot-id }{off|on}
Parameters
interface interface Enter the following keywords and slot/port or number information:
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a Gigabit Ethernet interface, enter the keyword gigabitethernet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Port Extenders (PE) 1293