Administrator Guide

NOTE: You must ensure that the port extender units are offline before you issue the no pe
provision command.
Example
DELL(conf)# pe provision 10
DELL(conf-pe-10)#
DELL(conf)# no pe provision 10
DELL(conf)# pe provision 0
DELL(conf-pe-0)# stack-unit 0 type N2048-PE
DELL(conf-pe-0)# stack-unit 1 type N2024P-PE
DELL(conf-pe-0)# cascade interface TenGigabitEthernet 0/14-15
DELL(conf-pe-0)# description Test
DELL(conf-pe-0)# stack-unit 0 description first
DELL(conf-pe-0)# stack-unit 1 description second
Related
Commands
• feature extended-bridge
• stack unit
• show pe
pe-version-compat-support
Enables the scheduled PE reboot feature.
Syntax
pe-version-compat-support enable
Defaults Enable.
Parameters
enable Enter the keyword enable to turn on the scheduled PE reboot feature.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010.
Usage Information
This command adds an entry to the startup-config file. Once this feature is enabled, it is available for all PEs.
reset pe schedule
Configure the PEs to reset or reboot at a specified period of time.
Syntax
reset pe schedule {after HHHH:MMMM | at [HHHH:MMMM-DD:MM:YR | HHHH:MMMM]}
{range pe-id-pe-id}
Defaults None.
Parameters
after
HHHH:MMMM
Enter the keyword after followed by the amount of time in hours and minutes after
which the PEs should reboot.
at HHHH:MMMM Enter the keyword at followed by the exact time on the current date at which the PEs
should reboot.
at HHHH:MMMM-
DD:MM:YR
Enter the keyword at followed by the exact date and time at which the PEs should
reboot.
1296 Port Extenders (PE)