Administrator Guide

Example
Dell#show pe errors
PE-id: Not Assigned
PE MAC: f8:b1:56:00:01:04
Interface Errors:
TenGigabitEthernet 1/16 - Error State
Dell#show pe 9
Codes: A - Active, I - Inactive
SVC - Software Version Compatible
Reason: CTM - Card Type Mismatch, CAM - CAM ACL Mismatch
SVM - Software Version Mismatch, UE - Unknown Error
Offline Reason: UNP - Unit Not Present, PVE - Port Validation Error
ICE - IPC CP Error, IRE - IPC RP Error
ISE - IPC Setup Error, CVE - Card Validation Error
PE-ID assigned: 9
Status: online
System Mac: f8:b1:56:00:01:28
PE Up Time: 08:36:56
PE Discovery Status: Provisioned PE
User Configured Cascade Ports: Te 1/9(A),Te 1/16(I)
Cascade LAG: Po 267(Up)
----------------------------------------------------------------------
Stack-id Status Reason Type UnitMac No. of Ports
---------------------------------------------------------------------
0 online - C1048P f8:b1:56:00:02:24 52
1 online - C1048P f8:b1:56:00:01:28 52
2 online - C1048P f8:b1:56:00:01:90 52
3 online - C1048P 00:00:ab:00:00:2c 52
Dual Homing
Use the commands in the following section to setup the configurations on a port extender connected in a dual-homing environment.
batch-write-memory
Saves the running configuration in both the VLT peers.
Syntax
batch-write-memory
Parameters None
Defaults None
Command Modes
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.13(0.0) Introduced on the C9010.
Usage Information If the batch-write-memory command fails on one of the VLT peers, it does not affect the operation in the other
VLT peer. Instead, an appropriate error message is displayed.
Example
Primary VLT
DellEMC(conf-b)#batch-write-mem
DellEMC(conf-b)#Dec 6 11:33:35 %RPM1-P:CP %FILEMGR-5-FILESAVED: Copied
running-config to startup-config in flash by default
Dec 6 11:33:36 %RPM1-P:CP %CLIBATCH-6-CLIBATCH_PEER_CONFIG_WRITE_COMPLETE:
Copy of running-config to startup-config in VLT peer flash is successful
Port Extenders (PE) 1305