Administrator Guide

commit write
Use commit write to apply the common configurations made in the Configuration Terminal Batch mode and to save the running
configuration in both VLT peers.
C9000 Series
Syntax
commit write
Parameters None
Default None
Command Modes CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13(0.0) Introduced on the C9010.
Usage Information
The Configuration Terminal Batch mode is used to setup common configurations on a port extender connected in
a dual-homing environment. Use the commit write command to apply the configuration changes. It also saves
the running configuration to the startup configuration in both VLT peers. In the Configuration Terminal Batch
mode, you can continue to commit the changes without exiting the batch mode.
NOTE: If the commit write command fails on one VLT peer, your configuration is not applied on
both VLT peers.
Example
Primary VLT
DellEMC(conf-b)#int range Tengigabitethernet 3/0 - 5
DellEMC(conf-if-range-te-3/0-5)#mtu 3500
DellEMC(conf-if-range-te-3/0-5)#exit
DellEMC(conf-b)#show conf
interface range tengigabitethernet 3/0 - 5
mtu 3500
DellEMC(conf-b)#commit write
DellEMC(conf-b)#Dec 6 11:31:58 %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in progress
Dec 6 11:31:58 %RPM1-P:CP %FILEMGR-5-FILESAVED: Copied running-config to
startup-config in flash by default
Dec 6 11:31:59 %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch
configuration commit is success
Dec 6 11:31:59 %RPM1-P:CP %CLIBATCH-6-CLIBATCH_PEER_CONFIG_WRITE_COMPLETE:
Copy of running-config to startup-config in VLT peer flash is successful
Secondary VLT
DellEMC#Dec 6 10:44:31 %RPM1-P:CP %CLIBATCH-6-
CLI_BATCH_CONFIG_IN_PROGRESS_TRAP: Batch configuration commit is in progress
Dec 6 10:44:31 %RPM1-P:CP %CLIBATCH-6-CLI_BATCH_CONFIG_COMPLETE_TRAP: Batch
configuration commit is success
Dec 6 10:44:31 %RPM1-P:CP %FILEMGR-5-FILESAVED: Copied running-config to
startup-config in flash by default
Related
Commands
• commit — apply the common configuration changes made in the Configuration Terminal Batch mode.
Port Extenders (PE) 1307