Administrator Guide

10 Primary Yes Po 1
Te 0/2
102 Isolated Yes Te 0/4
Related
Commands
private-vlan mode – sets the mode of the selected VLAN to community, isolated, or primary.
show interfaces private-vlan – displays type and status of PVLAN interfaces.
switchport mode private-vlan – sets PVLAN mode of the selected port.
switchport mode private-vlan
Set PVLAN mode of the selected port.
C9000 Series
Syntax
[no] switchport mode private-vlan {host | promiscuous | trunk}
To remove PVLAN mode from the selected port, use the no switchport mode private-vlan command.
Parameters
host Enter the keyword host to configure the selected port or port channel as an isolated
interface in a PVLAN.
promiscuous Enter the keyword promiscuous to configure the selected port or port channel as a
promiscuous interface.
trunk Enter the keyword trunk to configure the selected port or port channel as a trunk port
in a PVLAN.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage Information
The assignment of the various PVLAN port types to port and port channel (LAG) interfaces is shown in the
following example.
Example
Dell#conf
Dell(conf)#interface TenGigabitEthernet 2/1
Dell(conf-if-te-2/1)#switchport mode private-vlan promiscuous
Dell(conf)#interface TenGigabitEthernet 2/2
Dell(conf-if-te-2/2)#switchport mode private-vlan host
Dell(conf)#interface TenGigabitEthernet 2/3
Dell(conf-if-te-2/3)#switchport mode private-vlan trunk
1348 Private VLAN (PVLAN)