Administrator Guide
Version Description
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
The dot1p-priority command changes the priority of incoming traffic on the interface. The system places
traffic marked with a priority in the correct queue and processes that traffic according to its queue.
When you set the priority for a port channel, the physical interfaces assigned to the port channel are configured
with the same value. You cannot assign the dot1p-priority command to individual interfaces in a port
channel.
rate police
Police the incoming traffic rate on the selected interface.
C9000 Series
Syntax
rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]]
[vlan vlan-id]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps).
committed-rate
Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB
(OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The default is
50.
peak
peak-rate
(OPTIONAL) Enter the keyword peak then a number to specify the peak rate in Mbps.
The range is from 0 to 40000.
vlan
vlan-id
(OPTIONAL) Enter the keyword vlan then a VLAN ID to police traffic to those specific
VLANs. The range is from 1 to 4094.
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged and untagged switched
traffic and for Layer 3 traffic. Per VLAN rate limit and rate police is supported on only tagged
ports with Layer 2 switched traffic.
1358 Quality of Service (QoS)