Administrator Guide

Version Description
6.1.1.1 Introduced on the E-Series.
Usage Information The input policy map is used to classify incoming traffic to different flows using class-map, QoS policy, or
incoming packets DSCP. This command enables Policy-Map-Input Configuration mode (conf-policy-map-in).
When you configure an input policy map for CoPP, you must enter the keyword cpu-qos.
Use this command in Configuration Terminal Batch mode to create an input policy map in a dual-homing setup.
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS using policy maps.
service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
C9000 Series
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
Defaults none
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the C-Series and S-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
To assign traffic to different flows using QoS policy, use the Output Policy map. This command enables Policy-
Map-Output Configuration mode (conf-policy-map-out).
Use this command in Configuration Terminal Batch mode to create the Output Policy map in a dual-homing setup.
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS using policy maps.
service-policy output — applies an output policy map to the selected interface.
Quality of Service (QoS) 1371