Administrator Guide

offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
C9000 Series
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in | out} offset
[interface] command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine which incoming routes are
modified.
offset Enter a number from zero (0) to 16 to be applied to the incoming route metric matching
the access list specified. If you set an offset value to zero (0), no action is taken.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information When the offset metric is applied to an interface, that value takes precedence over an offset value that is not
extended to an interface.
Related
Commands
ip prefix-list — enters PREFIX-LIST mode and configure a prefix list.
1432 Routing Information Protocol (RIP)