Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1451

Defaults Not configured.

Command Modes LINE

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Commands

line — applies an authentication method list to the designated terminal lines.

ip access-list standard — names (or selects) a standard access list to filter based on the IP address.

ip access-list extended — names (or selects) an extended access list based on the IP addresses or protocols.

enable password

Change the password for the enable command.

C9000 Series

Syntax

enable password [level level] [encryption-type] password

To delete a password, use the no enable password [encryption-type] password [level

level] command.

Parameters

level

(OPTIONAL) Enter the keyword level then a number as the level of access. The range

is from 1 to 15.

encryption-type

(OPTIONAL) Enter the number 7 or 0 as the encryption type.

Enter a 7 then a text string as the hidden password. The text string must be a password

that was already encrypted by a Dell Networking router.

Use this parameter only with a password that you copied from the show running-

config file of another Dell Networking router.

password

Enter a text string, up to 32 characters long, as the clear text password.

Defaults No password is configured. level = 15.

Command Modes CONFIGURATION