Administrator Guide

sflow ingress-enable
Enable sFlow ingress on interfaces.
C9000 Series
Syntax
sflow ingress-enable
To disable sFlow, use the no sflow ingress enable command.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S-Series, Z-Series, and MXL switch.
Usage Information When you enable ingress sFlow on an interface, flow sampling is done on any incoming traffic.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from the LAG
port.
Related
Commands
sflow enable (Global) — turns sFlow globally.
sflow extended-switch enable
Enable packing information on a switch only.
C9000 Series
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable] command.
Parameters
enable Enter the keyword enable to enable global extended information.
Defaults Disabled.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.8(0.0P5) Introduced on the S4048-ON.
sFlow 1537