Administrator Guide

upload trace-log
Upload a trace log file from a switch CPU.
C9000 Series
Syntax
upload trace-log {cp [cmd-history]| linecard | slot-id | pe pe-id [stack-unit
unit number ] |rp } [sw-trace | hw-trace]
Parameters
rp Enter the keyword rp to upload a trace log from the Route Processor.
cp Enter the keyword cp to upload a trace log from the Control Processor.
linecard slot-id Enter the linecard slot-id parameters to specify the line-card CPU whose trace
log you want to upload.
cmd-history Enter the keyword cmd-history to upload the command history from the specified
CPU.
hw-trace Enter the keyword hw-trace to upload the hardware trace log from the specified CPU.
sw-trace Enter the keyword sw-trace to upload the software trace log from the specified CPU.
pe pe-id Enter the keyword pe and port extender ID. Range is from 0 to 255.
NOTE: The pe option is only available when the extended bridge feature is
enabled.
stack unit number Enter the keyword stack unit and a stack unit number. Stack unit range is from 0 to
7.
Defaults None.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
Usage Information
Trace log information is uploaded to flash:/TRACE_LOG_DIR
In a dual homing setup, you can use this command only from the primary VLT peer.
util-threshold cpu
Configure the high or low CPU utilization thresholds for SNMP traps.
C9000 Series
Syntax
util—threshold cpu {5sec | 1min | 5min} {all | cp |lp slot–id | pe | rp} {high
{0-100} | low {0-100}}
Parameters
cpu-utilization-
time
Enter one of the following values to configure the threshold level for the time in which a
switch CPU can be used:
156 Control and Monitoring