Administrator Guide
File Management
This chapter contains command line interface (CLI) commands needed to manage the configuration files as well as other file management
commands.
The commands in this chapter are supported by the Dell Networking OS on the C9000 switch.
Topics:
• boot system
• cd
• copy
• delete
• dir
• format flash
• mkdir
• mount nfs
• pwd
• rename
• restore factory-defaults
• rmdir
• show boot bmp
• show boot system
• show bootvar
• show file
• show file-systems
• show os-version
• show running-config
• show startup-config
• upgrade
• upgrade system-image-os6
• verify
boot system
Specify the location where the Dell Networking OS image used to boot the system is stored.
C9000 Series
Syntax
boot system [gateway ip address | [rpm0 {default | primary |secondary [ftp: |
system:{A:| B:} | tftp:] }] [rpm1 {default | primary | secondary [ftp: |system:
{A:|B:} | tftp:]}]
Parameters
gateway Enter the IP address of the default next-hop gateway for the management subnet.
ip-address
Enter an IP address in dotted decimal format.
rpm0 Enter the keyword rpm0 to specify the route processor module 0.
rpm1 Enter the keyword rpm1 to specify the route processor module 1.
default Enter the keyword default to use the default Dell Networking OS image.
primary Enter the keyword primary to use the primary Dell Networking OS image.
secondary Enter the keyword secondary to use the secondary Dell Networking OS image.
4
File Management 161