Administrator Guide

SupportAssist Activity Commands
Dell Networking OS supports the following SupportAssist Activity mode commands.
action-manifest get
Copy an action-manifest file for an activity to the system.
Syntax
action-manifest get tftp | ftp | flash <file-specification> <local-file-name>
Parameters
file-specification
Enter the full file specification for the action-manifest file. For example:
• tftp://hostip/filepath
• ftp://userid:password@hostip/filepath
• scp://userid:password@hostip/filepath
local-file-name Enter the name of the local action-manifest file, up to 32 characters long. Allowable
characters are: a to z, A to Z, 0 to 9, -, _, and space.
Command Modes
SUPPORTASSIST ACTIVITY FULL-TRANSFER
SUPPORTASSIST ACTIVITY EVENT-TRANSFER
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the M I/O Aggregator and FN IOM.
9.10(0.0) Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON,
Z9500, MXL.
Usage Information
The remote file specification for full transfer includes the protocol that is used to copy the file from the remote
system.
The default Manifest-file for full transfer includes records like alarms, logs, operational, and configuration data.
Related
Commands
• action-manifest install — configure the action-manifest to use for a specific activity.
• action-manifest show — view the list of action-manifest for a specific activity.
• action-manifest remove — remove the action-manifest file for an activity.
action-manifest install
Configure action-manifest to transfer a set of customized records for full transfer and to monitor a set of specified events for event
transfer.
Syntax
action-manifest install {default | <local-file-name>}
To revert to the default action-manifest file, use the action-manifest install default command.
Parameters
default Enter the keyword default to revert back to the default set of actions for an activity.
local-file-name Enter the name of the local action-manifest file. Allowable characters are: a to z, A to Z, 0
to 9, -, _, and space.
Defaults Default
Command Modes
SUPPORTASSIST ACTIVITY FULL-TRANSFER
SUPPORTASSIST ACTIVITY EVENT-TRANSFER
SupportAssist 1621