Administrator Guide

show running-config uplink-state-group
Display the current configuration of one or more uplink-state groups.
C9000 Series
Syntax
show running-config uplink-state-group [group-id]
Parameters
group-id Displays the current configuration of all uplink-state groups or a specified group. The valid
group-id values are from 1 to 16.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Example
Dell#show running-config uplink-state-group
!
no enable
uplink state track 1
downstream TengigabitEthernet 0/2,4,6,11-19
upstream TengigabitEthernet 0/48, 52
upstream PortChannel 1
!
uplink state track 2
downstream TengigabitEthernet 0/1,3,5,7-10
upstream TengigabitEthernet 0/56,60
Related
Commands
• show uplink-state-group — displays the status information on a specified uplink-state group or all groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
show uplink-state-group
Display status information on a specified uplink-state group or all groups.
C9000 Series
Syntax
show uplink-state-group [group-id] [detail]
Parameters
group-id Displays status information on a specified uplink-state group or all groups. The valid
group-id values are from 1 to 16.
detail Displays additional status information on the upstream and downstream interfaces in each
group
Uplink Failure Detection (UFD) 1663