Administrator Guide

Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group configuration
information, including defaults.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP group.
C9000 Series
Syntax
show vrrp [vrrp-id] [interface | brief | ipv6 | vrf vrf-name]
Parameters
vrrp-id
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to view only that
group. The range is from 1 to 255.
interface
OPTIONAL) Enter the following keywords and slot/port or number information:
For Port Channel interface types, enter the keywords port-channel then the
number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID range
is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
ipv6 (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
vrf
vrf-name
(OPTIONAL) Enter the keyword vrf and then the name of the VRF to view active VRRP
groups corresponding to that VRF.
Command Modes
EXEC
EXEC Privilege
Virtual Router Redundancy Protocol (VRRP) 1697