Administrator Guide

Usage Information If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No Active VRRP group.
C9000 Series
Syntax
show vrrp ipv6 [vrid] [interface] [brief][vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP group to view only that
group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID range
is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP
groups.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view IPv6 VRRP groups
corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON. Added support for VRF.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage Information The following describes the show vrrp ipv6 command shown in the following example.
Line Beginning
with
Description
GigabitEthernet... Displays the Interface, the VRRP group ID, and the network address. If the interface is no
sending VRRP packets, 0.0.0.0 appears as the network address.
VRF VRF instance to which the interface (on which the VRRP group is configured) belongs.
State: master... Displays the interface’s state:
• Na/If (not available).
Virtual Router Redundancy Protocol (VRRP) 1707