Administrator Guide

Where the default values are as follows: dot1x server-timeout (30 seconds), radius-server retransmit (3
seconds), and radius-server timeout (5 seconds).
For example:
Dell(conf)#radius-server host 10.11.197.105 timeout 6
Dell(conf)#radius-server host 10.11.197.105 retransmit 4
Dell(conf)#interface tengigabitethernet 2/23
Dell(conf-if-te-2/23)#dot1x server-timeout 40
Use this command in Interface Batch Mode to configure the server time-out in a dual-homing setup.
dot1x static-mab
Enable static MAC authorization bypass (MAB) and configure static MAB profile to an interface.
Syntax
[no] dot1x static-mab profile profile-name
Parameters
profile profile-
name
Enter the keyword profile and the profile-name to configure the static MAB profile
name. The profile name length is limited to 32 characters.
Defaults Disabled.
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000, S6000,
S6000–ON, the Configuration Terminal Batch mode on C9010, Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage Information
The dot1x static-mab command enables static MAB (mac auth bypass) and configures the associated
profile on a dot1x interface. Static MAB bypasses the authentication server for the supplicant MAC addresses
configured in the associated profile.
Before you enable static MAB, you must do the following:
• Enable MAC authentication bypass on the port by configuring the dot1x mac-auth-bypass command.
• Ensure that no configured profile exists at the time of configuring the static-mab command.
• Use this command in Interface Batch Mode to enable static MAB in a dual-homing setup.
Example
Dell(conf)#do show dot1x interface ten gigabit ethernet 0/41
802.1x information on Te 0/41:
----------------------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: AUTHORIZED (STATIC-MAB)
Re-Authentication: Enable
Untagged VLAN id: 400
Guest VLAN: Enable
Guest VLAN id: 400
Auth-Fail VLAN: Enable
Auth-Fail VLAN id: 400
Auth-Fail Max-Attempts: 3
Critical VLAN: Enable
Critical VLAN id: 400
Mac-Auth-Bypass: Disable
Mac-Auth-Bypass Only: Disable
Static-MAB: Enable
Static-MAB Profile: Sample
204 802.1X