Administrator Guide

Example
Dell(conf)#dot1x profile mySupplicants
Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
Dell(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
Dell(conf-dot1x-profile)#
Dell(conf-dot1x-profile)#exit
show dot1x cos-mapping interface
Display the CoS priority-mapping table the RADIUS server provides and applies to authenticated supplicants on an 802.1X-enabled system.
C9000 Series
Syntax
show dot1x cos-mapping interface interface [mac-address mac-address]
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
mac-address (Optional) MAC address of an 802.1X-authenticated supplicant.
Defaults none
Command Modes
• EXEC
• EXEC privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
Usage Information
Enter a supplicant’s MAC address using the mac-address option to display CoS mapping information only for
the specified supplicant.
You can display the CoS mapping information applied to traffic from authenticated supplicants on 802.1X-enabled
ports that are in Single-Hot, Multi-Host, and Multi-Supplicant authentication modes.
Example
Dell#show dot1x cos-mapping interface gigabitethernet 2/21
802.1p CoS re-map table on Gi 2/21:
----------------------------------
Dot1p Remapped Dot1p
0 7
1 6
802.1X 207