Administrator Guide

Usage Information
After enabling the acloptimized feature, reboot the system.
Example
DellEMC(conf)#feature acloptimized
Configuration change will be in effect after save and reload. ACL config
containing TTL, layer3 and VRF conflicts with ACL Cam optimzation feature
and these keywords would be discarded while applying the ACL.
ip access-list standard
Create a standard IP access list (IP ACL) to filter based on IP address.
C9000 Series
Syntax
ip access-list standard access-list-name
To delete an access list, use the no ip access-list standard access-list-name command.
Parameters
access-list-name Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit “deny any”; that is, if no match occurs, the packet is dropped. ACL permit/
deny rules are applied when a packet matches the condition in an entry.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to version 7.8.1.0, names
are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage Information
The system supports one ingress and one egress IP ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed information on the number entries
allowed per ACL on the C9000, refer to the Content Addressable Memory (CAM) chapter in the C9000
Configuration Guide.
Use this command in Configuration Terminal Batch mode to create a standard IP access list in a dual-homing
setup.
Access Control Lists (ACL) 221