Administrator Guide

Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information The continue feature allows movement from one route-map entry to a specific route-map entry (the sequence
number). If you do not specify the sequence number, the continue feature simply moves to the next sequence
number (also known as an implied continue). If a match clause exists, the continue feature executes only after
a successful match occurs. If there are no successful matches, the continue feature is ignored.
Match clause with Continue clause
The continue feature can exist without a match clause. A continue clause without a match clause executes and
jumps to the specified route-map entry.
With a match clause and a continue clause, the match clause executes first and the continue clause next in a
specified route map entry. The continue clause launches only after a successful match. The behavior is:
• A successful match with a continue clause, the route map executes the set clauses and then goes to the
specified route map entry upon execution of the continue clause.
• If the next route map entry contains a continue clause, the route map executes the continue clause if a
successful match occurs.
• If the next route map entry does not contain a continue clause, the route map evaluates normally. If a match
does not occur, the route map does not continue and falls through to the next sequence number, if one exists.
Set Clause with Continue Clause
If the route-map entry contains sets with the continue clause, set actions are performed first then the continue
clause jumps to the specified route map entry.
• If a set action occurs in the first route map entry and then the same set action occurs with a different value in
a subsequent route map entry, the last set of actions overrides the previous set of actions with the same set
command.
• If set community additive and set as-path prepend are configure, the communities and AS
numbers are prepended.
Related
Commands
set community — specifies a COMMUNITY attribute.
set as-path — configures a filter to modify the AS path.
description
Add a description to this route map.
C9000 Series
Syntax
description {description}
276 Access Control Lists (ACL)