Administrator Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information
CAUTION: Dell Networking recommends that you do not change the administrative distance of
internal routes. Changing the administrative distances may cause routing table inconsistencies.
The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes
assigned an administrative distance of 255 are not installed in the routing table.
Routes from confederations are treated as internal BGP routes.
ipv6 prefix-list
Configure an IPv6 prefix list.
C9000 Series
Syntax
ipv6 prefix-list prefix-list name
Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list names.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
Related
Commands
show ipv6 prefix-list — View the selected IPv6 prefix-list.
maximum-paths
Configure the maximum number of parallel routes (multipath support) BGP supports.
C9000 Series
Syntax
maximum-paths {ebgp | ibgp} number
To return to the default values, use the no maximum-paths command.
Parameters
ebgp Enter the keyword ebgp to enable multipath support for External BGP routes.
ibgp Enter the keyword ibgp to enable multipath support for Internal BGP routes
Border Gateway Protocol 445